Monday, February 1, 2010

Electronic Goldmine Geiger Counter Kit

As Mike Manes of EOSS suggested, I ran the geiger counter in a vacuum to make sure it didn't arc over. The tube has 600 volts across it, so this is an issue in low air pressure conditions. At first it looked fine. Then at 28 inches of mercury vacuum (about 94% vacuum), the LED indicator remained on. Some where the 600 volts was finding a ground and triggering the LED. I started coating the circuit in hot glue and have it running at lower pressures, but stil not in a full vacuum. I ran out of hot glue to do any more work, so I'll work again in this tomorrow.

3 comments:

  1. Normally, a vacuum should be less apt to arc. It's the "impurities" in the air that cause arcing.

    ReplyDelete
  2. Air should act as an insulator (not a very good one) and prevent high voltage from pushing electrons across a gap of high voltage and ground. The lower the air pressure, the easier it should be for electrons to make the jump. Different gases have lower ionization potentials, so that does make a difference.

    The effect I'm dealing with in this test is arcing that occurs because the high voltage lead is too close to to a lower potential (probably ground). After insulating the high voltage leads on the GM tube, arcing stopped in a vacuum.

    ReplyDelete